CNC machine tool track calculation

For CNC machine tools, if there is no tool compensation command, only the motion track size of the tool point can be calculated, and then programmed according to this, or local compensation processing. 1. Calculation of tool center (tool position) track CNC machine tool, if there is no tool compen ...more...

Posted on

Zhengzhou's first industrial park academician works…

On the morning of November 15, the academician workstation of Zhengzhou New Material Industrial Park was officially established in Fuyang City, which marked a solid step in the road of building a 100 billion industrial base. Academician of the Chinese Academy of Sciences, founder of the National Ke ...more...

Posted on

Organophosphorus pesticides cannot be used as foliar fe…

Some people have analyzed that the active constituents of organophosphorus pesticides contain phosphorus, which is an essential nutrient for plants. Therefore, the use of organic phosphorus has a certain effect on the growth of plants. It has also been observed that some crops ...more...

Posted on

Paint Engineering Safety Protection Measures

The safety protection measures for paint engineering are often due to the fact that the paint often contains lacquer, stupid, copper and other toxic substances. Prolonged contact can easily cause occupational poisoning. Therefore, the following safety precautions should be observed during the const ...more...

Posted on

RF admittance level gauge instructions

RF admittance is a new level control technology developed from capacitive, anti-hanging, more reliable, more accurate and more applicable. It is an upgrade of capacitive level technology. RF admittance is a new level control technology developed from capacitive, anti-hanging, more reliable, more ...more...

Posted on

Stainless steel surface carving and processing

Stainless steel surface and process have common problems 1. Weld defects: weld defects are serious, using manual stainless steel "target=_blank> stainless steel surface and common problems in processing 1. Weld defects: welds The defects are more serious, and the manual mechanical grinding ...more...

Posted on

High-speed disc bioseparation centrifuge technical indi…

Maximum separation factor: is the ratio of the centrifugal force to the gravity of the material. High-speed disc bioseparation centrifuge technical indicators: 1. Maximum diameter of the drum: refers to the diameter of the largest part of the drum. 2. Maximum speed: refers to the maximum speed ...more...

Posted on